Update Notes for 22nd of October

Chip Builder · published · build 26129336

TITLE
Chip Builder update: 2D board view

SUMMARY
Switch any breadboard level to a flat 2D board, watch current flow through your circuit, and click a chip to see what every pin does.

BODY

New: 2D board view

  • Switch any breadboard level between 3D and a flat 2D board. Use the 2D VIEW button, press V, or pick your favourite under BOARD VIEW on the main menu.
  • Wires route themselves in clean right angles, and your circuit stays exactly as you left it when you switch views.
  • Click an input and watch the change travel gate by gate to the outputs. Wires carrying a 1 glow with moving pulses.
  • Everything works in 2D: placing, wiring, moving parts, selecting several with Shift + drag, SHOW SOLUTION and RUN TESTS.

New: pin guide


Click a chip with four or more pins to see every pin's name, whether it is an input or an output, and its live value. On a crowded board the view zooms in on the chip, and it glides back when you close the guide.

A better 3D board

  • Clicking an input now drives the whole circuit, so you can try your design by hand before you hit RUN TESTS. Before, a click lit the pad but went no further.
  • Pins and pads show their real value: green for 1, grey for 0.
  • Pin names sit on each chip's lid and stay readable. Point at a chip to bring its names forward; small names appear as you zoom in.
  • Connectors on the far side of tall chips are no longer hidden.
  • A see-through preview shows where a new part will land.
  • SHOW SOLUTION and RESET VIEW now frame the whole circuit.

Fixes

  • Parts can no longer be placed or dragged off the breadboard and SHOW SOLUTION no longer leaves parts hanging past the board's edge.
  • The "board is full" message now shows in full.
  • The test count was removed. The results panel still tells you how many cases are waiting.
Update Notes for 22nd of October · Chip Builder patch notes · SteamPeaks