TITLE
Chip Builder update: 2D board view
SUMMARY
Switch any breadboard level to a flat 2D board, watch current flow through your circuit, and click a chip to see what every pin does.
BODY
New: 2D board view
- Switch any breadboard level between 3D and a flat 2D board. Use the 2D VIEW button, press V, or pick your favourite under BOARD VIEW on the main menu.
- Wires route themselves in clean right angles, and your circuit stays exactly as you left it when you switch views.
- Click an input and watch the change travel gate by gate to the outputs. Wires carrying a 1 glow with moving pulses.
- Everything works in 2D: placing, wiring, moving parts, selecting several with Shift + drag, SHOW SOLUTION and RUN TESTS.
New: pin guide
Click a chip with four or more pins to see every pin's name, whether it is an input or an output, and its live value. On a crowded board the view zooms in on the chip, and it glides back when you close the guide.
A better 3D board
- Clicking an input now drives the whole circuit, so you can try your design by hand before you hit RUN TESTS. Before, a click lit the pad but went no further.
- Pins and pads show their real value: green for 1, grey for 0.
- Pin names sit on each chip's lid and stay readable. Point at a chip to bring its names forward; small names appear as you zoom in.
- Connectors on the far side of tall chips are no longer hidden.
- A see-through preview shows where a new part will land.
- SHOW SOLUTION and RESET VIEW now frame the whole circuit.
Fixes
- Parts can no longer be placed or dragged off the breadboard and SHOW SOLUTION no longer leaves parts hanging past the board's edge.
- The "board is full" message now shows in full.
- The test count was removed. The results panel still tells you how many cases are waiting.