Build 26493057

This update adds the following...

1. You can now create a Priority Fire Zone (PFZ) which allows your wingmen to efficiently engage targets in a desired area.You can create a fire zone by using the TSD MFD display. Move the cursor to where you want the centre of the PFZ to be created and then use the new "Toggle Priority Fire Zone" bindable command or use the MFD "TGL PFZ" button command - "Modifier 1 (usually left bumper)" + "Button 7 (usually Y)"When the PFZ is active you will then see a yellow circle drawn on the TSD. This shows the area covered by the PFZ.To cancel the PFZ simply use the same command again and the circle will disappear.Once the PFZ is set, using "Next Target" & "Previous Target" will cycle you through the targets within the PFZ. This makes it extremely useful when you want to focus on the targets in a particular area even if you don't have any wingmen with you.If you do have wingmen then you can tell them to engage targets within the PFZ by issuing the "Engage PFZ: Standoff" command either as a group or individually. Your wingmen will then use standoff weaponry (i.e. long range guided weapons) to attack the targets within the PFZ.The PFZ system will automatically distribute targets based on priority (e.g. SAM 1st, AAA 2nd etc) to your wingmen so that they all engage different targets at the same time. You can also join in the fun using "next target" & "previous target" and the PFZ will not let you target anything already under attack from your wingmen. ːsteamhappyːThings to Bear In MindIf you are locked onto a target in the PFZ then your wingmen will not engage it because they think you are going to attack it but this also allows you to safely attack units with rockets etc knowing your wingman isn't going to steal your kill, your gunner might though! ːsteamsunnyːPFZs only work on ground units marked on your TSD. Units detected in the PFZ after setting it will not be automatically added to the target list, you'll need to re-create the PFZ. The PFZ system will not target buildings. The PFZ does not work with the TSD priority filter. It always gets all targets in an area. However, high priority targets will be engaged 1st.

2. Fixed a graphical issue when flying through clouds.