How to align your Vive trackers (Steam Frame)
You need a Steam Frame, your base stations switched on and at least one Vive (Lighthouse) tracker. A second tracker for the room anchor is optional.
- 1. Open O·VR › CALIBRATE › AUTOMATIC and press Enable automatic alignment. If the page asks, first allow tracker changes on DRIVER (O·VR › TRACKERS).
- 2. Press a tracker firmly against one Frame controller and keep the two together while you measure. Your other hand stays free.
- 3. Press Start, then tilt and turn the pair together for a few seconds.
- 4. Take readings at spots spread across your space: the corners, the middle and each side of the room. At each spot, pull the trigger on your free controller (pointing anywhere but at the dash) or press Take reading, then tilt and turn the pair until the meter fills. The headset confirms each one (Reading 1 taken, Reading 2 taken...). Between readings you can walk, rest or re-grip the pair.
- 5. Press Done. It locks once your readings agree to ±2 cm, or to up to ±6 cm when you have six readings spread over 1.5 m. The page then reads ALIGNED · ROOM LOCKED.
- 6. Optional: a room anchor. Leave a spare tracker in a fixed spot where every base station can see it. Once it has stayed still for 10 seconds while you move, vrOS offers it: press Use as room anchor. The ROOM ANCHOR row then shows how far it has moved since the lock, steady or drifting, which tells you whether the Lighthouse tracking itself has drifted. Stop using turns it off.
The lock carries over to your next session. Press Re-check and hold the pair for 3 seconds to confirm it where you stand.
New Features
- Alignment by readings: tracker alignment is now a set of short readings you take yourself, as described above, instead of one continuous walk. Nothing is measured between readings, and the measurement never ends by itself: Done is yours to press. The ± now comes from checking each reading against a fit made without it, so it shows what your room really holds. Above 2 cm the ROOM LOCK figure turns amber and Done explains why. The page no longer lists base stations.
- Room anchor (optional): a spare tracker left in one place measures how far the Lighthouse tracking drifts during a session. The map shows it as a diamond.
- Trackers keep pace when you walk: Lighthouse trackers are now shown on the headset's timing, so a tracker held against a controller no longer runs ahead of it while you walk. This comes with an updated vrOS SteamVR driver: vrOS offers UPDATE AND RESTART, or installs it the next time SteamVR is fully closed.
- FACE TRACKING page for VRChat: the VRChat OSC tab in the dashboard has a new FACE TRACKING page. It shows which eyelid parameters vrOS found on your current avatar and the values it sends to VRChat, live.
- vrOS now also finds eyelid parameters with non-standard names (marked GUESSED). If it finds none, use one of the avatar's other eye parameters as its LEFT LID or RIGHT LID, or SWAP the two.
- COMBINED LID MODE (AUTO, ALWAYS, NEVER) sets, per avatar, whether VRChat's single combined eyelid value is sent too. AUTO holds it back while each eye is sent separately.
- Your changes are saved per avatar. OPEN VRCHAT OSC in O·VR › FACE TRACKING now opens this page.
Bug Fixes
- Setting the headset down no longer loses the alignment: when the headset's tracking jumps, for example after you put it down and pick it up again, vrOS now waits up to 10 seconds for the headset's own measurement of the move instead of dropping the lock straight away (with vrOS running on the headset).
Improvements
- Each alignment attempt saves a readings record next to vrOS's alignment log, without device serial numbers, so a bug report can include it.
Known Issues
- Tracker alignment is still in development. We're still working on how reliably the room lock holds through a long session.